xTool Riser Base for S1 Laser

Discover the full potential of your S1 Laser

Take your laser experience to the next level! With the xTool Riser Base for the S1, you can now insert materials with a height of up to 125mm and design them according to your wishes.

Whether it's a breakfast board, handbag, purse, storage box or whatever else you have in mind, the xTool Riser Base for the S1 gives you all the freedom you need!

Set up in just a few minutes

Breathe a sigh of relief for all those who have no craftsman training behind them:
The elevation is mounted with a few simple steps. All you have to do is move the base plate, position the laser on the Riser Base and then tighten a few screws.

"Must have" for all those with rotary extensions

For all those who like to engrave bottles, cups or rings, the Riser Base is a "must have", because the separately available Rotary Tool for the S1 Laser can only be used with the Riser Base.

The xTool Riser Base for the S1 can be purchased by both private individuals and businesses!

Scope of delivery:

• xTool Riser Base for S1
• Screws
• Instruction manual

Max. supported material thicknesses S1:

Without Riser Base:

Without Riser Base; without honeycomb panel: 42mm
Without Riser Base; with honeycomb panel: 15mm

With Riser Base:

With Riser Base and honeycomb panel: 99mm
With Riser Base; without honeycomb panel: 125mm